3.4.2 Mounting the controller with 19" rack mounting kit
General
The OmniCore E10 controller is designed to fit in a 19" cabinet.
xx2100001562
Note
If the controller is installed in a rack (cabinet), it must be fastened in a way that
prevents distortion of the controller cabinet. Preferably with angle bars along the
entire side edges of the controller.
Required equipment
InformationEquipment
3HAC077631-001Mounting kit
See Standard toolkit for controller on
page 202.
Standard toolkit
Continues on next page
Product manual - OmniCore E10 53
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Mounting the controller with 19" rack mounting kit
To Next Page
Loading...
