ABB OmniCore E10 - Page 54

Installing the 19" rack mounting kit to the controller
Use this procedure to install the controller in a 19" cabinet.
InformationAction
xx2100001311
Remove the screws on the right and left
sides.
1
Assemble the mounting kit.2
Torx pan head screw M6x16 (4 pcs)Place the controller into the 19" cabinet and
fasten it with the screws.
3
Tightening torque: 1.7-1.8 Nm
xx2100001563
54 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Mounting the controller with 19" rack mounting kit
Continued