5.3.2 Replacing the incoming mains connector
Location
The illustration shows the location of the incoming mains connector in the controller.
xx2100001328
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore E10 via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Harness-Mains connection3HAC075416-001Harness AC input with SW
Mating connector for Power inlet3HAC077706-001Connector AC power inlet
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 202.
-Standard toolkit
-ESD protective wrist band
Continues on next page
Product manual - OmniCore E10 153
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.2 Replacing the incoming mains connector
To Next Page
Loading...
