6.2 Troubleshooting fault symptoms
Fault symptoms described in this manual
This manual describes how to troubleshoot the following fault symptoms:
• No LEDs are lit on the controller on page 168
• Start-up failure on page 171
• Problem releasing the robot brakes on page 173
• Problem starting or connecting the FlexPendant on page 176
• Problem using the joystick on page 180
• Controller fails to start on page 181
• Reflashing firmware failure on page 182
• Inconsistent path accuracy on page 183
Continues on next page
Product manual - OmniCore E10 167
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
6 Troubleshooting
6.2 Troubleshooting fault symptoms
To Next Page