ABB OmniCore E10 - Page 162

Removing the joystick protection
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 41.
1
Disconnect the FlexPendant from the
controller.
2
xx1800001198
Remove the attachment screws.3
xx1800001199
Remove the joystick protection.4
Refitting the joystick protection
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 41.
1
Continues on next page
162 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.4.2 Replacing the joystick protection
Continued