ABB OmniCore E10 - Page 170

NoteAction
Check that the mains connection (X0) is properly
connected.
Tip
For more details, see Circuit diagram - OmniCore
E10.
3
• If abnormal, fix the connec-
tion.
• If normal, replace the power
inlet. See Replacing the in-
coming mains connector on
page 153.
Check that the AC input cable is properly connec-
ted.
4
170 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
6 Troubleshooting
6.2.1 No LEDs are lit on the controller
Continued