LEDs
The illustration below shows the indication LEDs on the drive unit.
xx2100001560
Ethernet LEDs (yellow)A
Ethernet LEDs (green)B
Status LEDC
SignificanceDescription
Shows the status of Ethernet communication between the drive unit and
the power unit.
Ethernet LEDs
Green:
• Off: 10 Mbps data rate is selected.
• On: 100 Mbps data rate is selected.
Yellow:
• Flashing: The two units are communicating on the Ethernet channel.
• Steady: A LAN link is established.
• Off: A LAN link is not established.
Continues on next page
Product manual - OmniCore E10 189
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
6 Troubleshooting
6.3.3 Troubleshooting the drive unit
Continued
To Next Page
Loading...
