Reference on
the circuit dia-
gram
LabelDescription
A2.X6X5I/O interfaceE
A2.X8HMIFlexPendant adaptor connector (HMI)F
A2.X1WAN1WAN1 portG
A2.X2WAN2WAN2 portH
A2.X5MON, AS/GS, ES,
ESOUT
Customer safety interfaceJ
A2.X3DEVICEDevice portK
A2.X4MGMTManagement portL
A2.X7X6External 24 V power inlet connectorM
Power inlet switch
Use the power inlet switch to turn on and off power to the controller. It is also
possible to restart the controller using the FlexPendant.
Note
When restarting the controller, wait until the computer and logic unit status LED
Computer has turned off before turning on power again.
Safety lock for power inlet switch
The following illustration shows the location of the safety lock for the power inlet
switch.
xx2100001300
Continues on next page
Product manual - OmniCore E10 63
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.1 Connectors on the OmniCore E10 controller
Continued
To Next Page
Loading...
