When detached, the FlexPendant will shut down.
Note
If the FlexPendant is not detached within 30 seconds, the process for
detach of the FlexPendant is aborted.
WARNING
If the FlexPendant is detached after the 30 seconds countdown has passed,
the controller will enter emergency stop state.
Attaching the FlexPendant
CAUTION
Always inspect the connector for dirt or damage before attaching. Clean or replace
any damaged parts.
Attach the connector to the controller and tighten the locking ring or screws.
Note
The OmniCore E10 controller has an adapter cable in between the controller and
the FlexPendant.
xx2100001343
CAUTION
Make sure that the emergency stop device is not pressed in before attaching the
FlexPendant.
78 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.6 Detaching and attaching a FlexPendant
Continued
To Next Page
Loading...
