The Public Network can be configured with a fixed IP address, or as a DHCP client,
either in RobotStudio or from the FlexPendant:
• Defining network settings in RobotStudio:
1 In the Configuration browser, right-click the controller and select
Properties\Network Settings and then Public Network.
2 In the Public Network window, configure the network interface and
click OK.
xx2000000489
• Defining network settings on the FlexPendant:
1 On the start screen, tap Settings, and then select Network from the
menu.
Continues on next page
Product manual - OmniCore E10 83
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.7 Ethernet networks on OmniCore
Continued
To Next Page
Loading...
