ABB REACT 2 Series - Connectivity

- 127 -
000906AG
7 - Operation
C onnectivity
In the Connectivity section it’s possible to access the following sub-
menus:
56
/$1
:/$1
0RGEXV
'HEXJ6HWWLQJV
RS485
In the RS485 sub-menu it’s possible to adjust the settings relating to the
RS485 communication serial line:
561RGH$GGUHVV,WDOORZV\RXWRVHWVWKHDGGUHVVIRUVHULDOFRP-
munication of the individual inverters connected to the RS485 line (The
addresses that can be assigned are 2 to 63).
56%DXG5DWH,WDOORZV\RXWRVHWVWKH%DXG5DWH
00/19200/34800/57600/115200).
563DULW\0RGH,WDOORZV\RXWRVHWWKH3DULW\ELW1R3DULW\(YHQ
Parity, Odd Parity).
563URWRFRO7\SH,WDOORZV\RXWRVHWVWKHW\SHRISURWRFROWREH
used for the RS485 line.
- “Modbus ABB Server”: General purpose communication protocol to
be selected to enable monitoring and control using ABB map.
- “Modbus Sunspec Server”: General purpose communication protocol to
be selected to enable monitoring and control using Sunspec standard.
- “Device Acquisition”: Communication protocol to be used in case of
connection in “Master” mode to external devices (like VSN800 wea-
ther station).
LAN
In the LAN sub-menu it’s possible to view the status and change the
GDLV\FKDLQFRQ¿JXUDWLRQRIWKHWZRHWKHUQHWSRUWVRIWKHLQYHUWHU
-
'DLV\FKDLQFRQ¿JXUDWLRQ'+&3RU6WDWLF:
By selecting the DHCP function (default setup) the rou-
ter will automatically assign a dynamic IP address to the in-
verter whenever it tries to connect to the user network.
:LWK6WDWLFWKHXVHUFDQDVVLJQD¿[HG,3DGGUHVVWRWKHV\VWHP7KH
data which has to be entered in order for IP static address assigning
WRWDNHSODFHZLOODSSHDU&RPSOHWHWKHDGGLWLRQDO¿HOGVDWWKHERWWRP
RI WKH VFUHHQ DOO WKH ¿HOGV DUH PDQGDWRU\ ZLWK WKH H[FHSWLRQ RI WKH
secondary DNS server).