ABB REACT 2 Series - Hazardous Areas and Operations; Environmental Conditions and Risks; Signs and Labels

- 46 -
000894AG
3 - Safety and accident prevention
Hazardous areas and operations
E nvironmental conditions and risks
The equipment is to be installed in locations with suitable environmental
conditions which observe the safety conditions and do not prevent its
regular operation. These conditions are listed in the technical data and in
the installation chapter.
ABB is not responsible for any loss of the equipment, or part of it, which
does not take place on the basis of the regulations and laws in force in
the country of installation.
The same precautions should be adopted for dismantling the equipment.
The equipment is not designed to operate in environments that are particularly LQÀDPPDEOH
or explosive.
IThe customer and/or installer must appropriately train operators or
anyone who may come into close proximity of the equipment, and
highlight, with notices or other means where necessary, the hazardous
areas or operations at risk : PDJQHWLF¿HOGVKD]DUGRXVYROWDJHVKLJK
WHPSHUDWXUHVSRVVLEOHGLVFKDUJHVJHQHULFKD]DUGHWF
Keep out of the reach of children
S igns and labels
7KH ODEHOV DI¿[HG RQ WKH HTXLSPHQW PXVW VWULFWO\ 127 EH UHPRYHG GDPDJHG GHIDFHG
hidden, etc.
The labels must be regularly cleaned and kept in sight, i.e. NOT hidden
by foreign objects and parts (rags, boxes, equipment, etc.)
The technical data provided in this manual does not in any case replace
WKDWVKRZQRQWKHODEHOVDI¿[HGRQWKHHTXLSPHQW