ABB tacteo KNX User Manual

ABB i-bus
®
KNX
Commissioning
FCA/S 1.x.x.1 | 2CDC508134D0202 195
3.2.4.4.2 Parameter options for KTY
This parameter window is visible if the option KTY has been selected in the parameter Input a in
Parameter window Enable inputs a…c, p. 170.
Manufacturer designation
Options:
KT 100 / 110 / 130
KT 210 / 230
KTY 10-5 / 11-5 / 13-5
KTY 10-6 / 10-62 / 11-6 / 13-6 / 16-6 / 19-6
KTY 10-7 / 11-7 / 13-7
KTY 21-5 / 23-5
KTY 21-6 / 23-6
KTY 21-7 / 23-7
KTY 81-110 / 81-120 / 81-150
KTY 82-110 / 82-120 / 82-150
KTY 81-121 / 82-121
KTY 81-122 / 82-122
KTY 81-151 / 82-151
KTY 81-152 / 82-152
KTY 81-210 / 81-220 / 81-250
KTY 82-210 / 82-220 / 82-250
KTY 81-221 / 82-221
KTY 81-222 / 82-222
KTY 81-251 / 82-251
KTY 81-252 / 82-252
KTY 83-110 / 83-120 / 83-150
KTY 83-121
KTY 83-122
KTY 83-151
User-defined
For selection of a predefined KTY sensor
Note
If a KTY sensor which is not in the list is used, the option KTY user-defined can be used to enter its
characteristic (see following page).

ABB tacteo KNX Specifications

General

Brand	ABB
Model	tacteo KNX
Category	Controller
Language	English