ABB tacteo KNX - Application Device Settings; Acoustic Feedback Signal - Application; Selected Feedback Signal Noise Is on

Description of application and parameters
Application "Device settings"
Product manual 2CKA001473B9482
│
51
11.3 Application "Device settings"
11.3.1 Acoustic feedback signal - Application
Options: Inactive
Buzzer application
■
Inactive:
– The application is not active.
■
Buzzer application:
– The application is active.
The application is used to specify whether an acoustic signal sounds when a button is pressed.
This signal can be adapted individually after the activation.
The following communication objects are available:
■
"BUZ: object activation of acoustic feedback signal"
■
"BUZ: triggering an alarm"
■
"BUZ: time for automatic deactivation of the alarm"
The communication objects are enabled via the associated parameters.
Note
The following parameters can only be adjusted when the function "Acoustic
feedback signal" is set on "Buzzer application".
The parameters for application "Acoustic feedback signal" can be called up via
general parameters .
11.3.1.1 Selected feedback signal noise is on
Options: Click
Beeping
■
Clicking:
– "Clicking" sounds at the press of the buttons.
■
Beeping:
– "Beeping" sounds at the press of the buttons.
The parameter us used to specify the type of acoustic signal for the feedback signal noise.