ABB tacteo KNX - Colour for Zone 2 (Starting at 1%); Threshold between Zone 2 and 3 (%)

Description of application and parameters
Application "Function block RTC"
Product manual 2CKA001473B9482
│
131
11.5.138.7 Colour for Zone 2 (starting at 1%)
Options: Off
Yellow
Red-orange
Red
Violet
Blue
Green
White
■
Off:
– The button LEDs are switched off.
■
Yellow - white:
– The button LEDs light up in the fixed colour at value telegrams for zone 2.
The parameter is used to specify the colour the button LEDs light up in when a telegram with a
value is received via the 1-byte communication object "Status LED", which meets the following
conditions:
■
Value is ≥ 1% and
■
Value is < S1.
The default setting is "yellow".
The threshold value S1 is set via the parameter "Threshold between Zone 2 and 3" (%).
Note
The parameter can only be set if the "Operating mode" parameter and is set on
"Status illumination" and the "Object type for status object" parameter is set on
"1 byte 0-100%".
11.5.138.8 Threshold between Zone 2 and 3 (%)
Options: Setting option from 1 to 98
The parameter is used to set the threshold value (S1) between Zone 2 and 3.
If the value received is < S1 and ≥ 1%, the button LEDs light up in the colour for zone 2.
If the value received is ≥ S1 and < S2, the button LEDs light up in the colour for zone 3.
Note
The parameter can only be set if the "Operating mode" parameter and is set on
"Status illumination" and the "Object type for status object" parameter is set on
"1 byte 0-100%".