36
9.4.2 Adjust temperature
Display of the set-point temperature
The set-point temperature appears automatically on the display. The device must be switched
on for this to happen.
Setting of the set-point temperature
1
2
4
3
The desired temperature is set with the
buttons [2] and [3]. The current set
temperature is shown on the display.
■
Press button [3] to raise the
temperature.
■
Press button [2] to lower the
temperature.
Fig. 25: RTC control elements
After an adjustable time the device changes back into the mode that was active before the
adjustment of the set-point temperature, e.g. into comfort operation. The stored set-point
temperature is displayed.
Note
The jump-back time of the device to the primary functions of the control
elements is specified via application "Control settings".
To Next Page
Loading...
