Description of application and parameters
Application "Device settings"
Product manual 2CKA001473B9482
61
11.3.3.2 After bus voltage recovery the device is
Options: Blocked
Enabled
■
Blocked:
– The enable object has value"1" after bus voltage recovery.
■
Enabled:
– The enable object has value "0" after bus voltage recovery.
The parameter serves to ensure that a defined behaviour is present on communication object
"EF: enable" after a return of bus voltage.
11.3.3.3 Use of automatic enable/blockage
Options: No
Automatic enable
Automatic blockage
■
No:
– No automatic enable or blockage of the device.
■
Automatic enable:
– Function "Automatic enable" is active.
■
Automatic blockage:
– Function "Automatic blockage" ia active.
The parameter can be used to automatically enable or automatically block the device.
11.3.3.4 Automatic switchover time
Options: Setting option from 00:00:10 to 18:00:00 (hh:mm:ss)
The switching on or switchover always occurs immediately the user has approached the device.
The switching off or switchover can be delayed via the parameter. In this way, for example, the
display stays switched on for a while longer although the user has just moved away from the
device.
Note
This parameter can only be adjusted when the "Use of automatic
enable/blockage" parameter is set on "Automatic enable" or "Automatic
blockage".
To Next Page
Loading...
