ABB tacteo KNX - Feedback Signal after Bus Voltage Recovery; Acoustic Alarm Via Object

Description of application and parameters
Application "Device settings"
Product manual 2CKA001473B9482
│
53
11.3.1.4 Feedback signal after bus voltage recovery
Options: Deactivated
Activated
■
Deactivated:
– Automatic deactivation after bus voltage recovery.
■
Activated:
– Automatic activation after bus voltage recovery.
If the "Acoustic feedback signal via object" is to start automatically after the bus voltage
recovery, the parameter "Feedback signal after bus voltage recovery" must be set on
"activated". If "deactivated has been selected, the "Acoustic feedback signal via object" does
not start after bus voltage recovery.
Note
The parameter can only be set when parameter "Acoustic feedback signal via
object" is activated.
11.3.1.5 Acoustic alarm via object
Options: Deactivated
Activated
■
Deactivated:
– The communication object is not enabled.
■
Activated:
– The communication object is enabled.
A 1-byte communication object "BUZ: trigger alarm" can be enabled with this parameter. The
further differentiation is carried out via the parameter that is available after enabling.
The alarm function can, for example, display a wind alarm or an open door when the user wants
to lower a blind or a roller blind.