Description of application and parameters
Application "Device settings"
Product manual 2CKA001473B9482
62
11.3.3.5 Switchover time via object
Options: Deactivated
Activated
■
Deactivated:
– The communication object is not enabled.
■
Activated:
– The communication object is enabled.
A 2-byte communication object "EF: automatic switchover time" can be enabled with this
parameter. The time can then be adjusted via the KNX bus.
Note
This parameter can only be adjusted when the "Use of automatic
enable/blockage" parameter is set on "Automatic enable" or "Automatic
blockage".
11.3.3.6 Overwrite switchover time at download
Options: Deactivated
Activated
■
Deactivated:
– The switchover time is not overwritten during a download of the application.
■
Activated:
– The switchover time is overwritten during a download of the application.
The parameter can be used to specify whether the data changed via communication object "EF:
automatic switchover time" are to be overwritten during the download or the times should be
retained.
Note
This parameter can only be adjusted when the "Use of automatic
enable/blockage" parameter is set on "Automatic enable" or "Automatic
blockage".
To Next Page
Loading...
