ABB tacteo KNX - Waiting Period for Display of Actual Temperature

Description of application and parameters
Application "Function block RTC"
Product manual 2CKA001473B9482
│
73
11.5.2.4 Waiting period for display of actual temperature
Options: 5 s
10 s
20 s
30 s
1 min.
2 min.
4 min.
The parameter is used to specify after which rest period the actual temperature is shown in the
display. This means that when the device is not operated within the set waiting period, the
current room temperature is displayed.
Note
The parameter is only adjustable if the "Display of actual temperature"
parameter is set on "Yes".