ABB tacteo KNX - Page 46

Description of application and parameters
Overview of functions
Product manual 2CKA001473B9482
│
46
Setpoint temperature heat protection (°C) 27 - 45
Display indicates
Current setpoint /
relative setpoint
Send current setpoint
Cyclic and at change / only
at change
Cyclic sending of the current setpoint
temperature (min)
5 - 240
Basic set value is
Setpoint cooling comfort /
setpoint heating comfort /
mean value between heating
comfort and cooling comfort
Function block RTC —
RTC — Setpoint
adjustment
Max. manual increase during heating mode
(0 - 9°C)
0 - 9
Max. manual reduction during heating mode
(0 - 9°C)
0 - 9
Max. manual increase during cooling mode
(0 - 9°C)
0 - 9
Max. manual reduction during cooling mode
(0 - 9°C)
0 - 9
Resetting of the manual adjustment for
receipt of a basic set value
No / yes
Resetting the manual adjustment for change
of operating mode
No / yes
Resetting the manual adjustment via object No / yes
Permanent storage of on-site operation No / yes
Function block RTC —
RTC — Temperaturer
reading
Inputs of temperature reading
Internal measurement /
external measurement /
weighted measurement
Inputs of weighted temperature reading
Internal and external
measurement / 2x external
measurement / internal and
2x external measurement
Weighting of internal measurement (0 to
100%)
0 - 100
Weighting of external measurement (0 to
100%)
0 - 100
Weighting of external measurement 2 (0 to
100%)
0 - 100
Cyclic sending of the actual temperature
(min)
5 - 240
Difference of value for sending the actual
temperature (x 0.1°C)
1 - 100
Adjustment value for internal temperature
measurement (x 0.1°C)
1 - 100
Monitoring time for temperature reading (0 =
no monitoring) (min)
0 - 120
Control value for fault (0 - 255) 0 - 255
Function block RTC —
RTC — Alarm function
Condensate water alarm No / yes
Dew point alarm No / yes
Frost alarm temperature for HVAC and
RHCC status (°C)
0 - 15
Heat alarm temperature for RHCC status
25 - 70