EasyManuals Logo

ABB tacteo KNX User Manual

ABB tacteo KNX
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #202 background imageLoading...
Page #202 background image
ABB i-bus
®
KNX
Commissioning
200 2CDC508134D0202 | FCA/S 1.x.x.1
Threshold 1 can be changed via the bus
Options:
No
Yes
This parameter specifies whether the limits can be changed via the bus.
Yes: The following communication objects appear:
Modify Input a Threshold 1 lower limit
Modify Input a Threshold 1 upper limit.
Important
The value formats of these communication objects are the same as the format set in parameter window
a: PT100/PT1000 or KTY, under the parameter Send output value as.
1-bit or 1-byte
Options:
1 bit
1-byte [0...+255]
Selection of option 1-bit:
Dependent parameters:
Send if threshold fallen below
Send if threshold exceeded
Options:
No telegram
ON telegram
OFF telegram
No telegram: No reaction occurs.
ON telegram: A telegram with the value 1 is sent.
OFF telegram: A telegram with the value 0 is sent.
Min. duration of the undershoot
Min. duration of the overshoot
Options:
None
5/10/30/60 seconds
2/3/5/10/30/60 minutes
2/3/5/10/12/24 hours
None: the threshold is sent directly.
With the further time options, a minimum duration can be selected. If the send condition reverts
during the minimum duration, no telegrams are sent.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB tacteo KNX and is the answer not in the manual?

ABB tacteo KNX Specifications

General IconGeneral
BrandABB
Modeltacteo KNX
CategoryController
LanguageEnglish

Related product manuals