ABB tacteo KNX User Manual

ABB i-bus
®
KNX
Commissioning
232 2CDC508134D0202 | FCA/S 1.x.x.1
94
Start event 0/1
Input a: Switch sensor
1 bit
DPT 1.001
C, W
This communication object is enabled if the parameter Enable communication object "Start event 0/1" 1-bit has been selected
with the option Yes in Parameter window a: Switch sensor, p. 171.
The 1-bit communication object Start event 0/1 is enabled. As a result, the same events, except those of the push
button/switch connected to the binary input, can also be triggered by the receipt of a telegram on the communication object
Start event 0/1.
Telegram value:
0 = Start event 0
1 = Start event 1
95…99
Not assigned
100…119
Input b, c

ABB tacteo KNX Specifications

General

Brand	ABB
Model	tacteo KNX
Category	Controller
Language	English