Procedure for dismantling the Inverter and wiring box
The inverter consists of an Inverter part and two DC and AC Wiring Boxes
which may be dismantled separately.
To dismantling and disassemble the appliance, refer to the chapters:
Mount using a support bracket
- Vertical wall mounting
- Mounting horizontally
Follow the indications for the mounting procedure but in the reverse order
Perform the steps for “Turning off the inverter” based on the model, before removing one of
the two wiring boxes or the inverter itself.
Never open the wiring boxes in the case of rain, snow or a level of humidity >95%.
Always carefully seal all unused openings.
Even though the device is equipped with an anti-condensation valve,
air with extremely high levels of humidity can lead to the creation of
condensation inside the inverter.
As the inverter is almost completely insulated from the outside,
condensation can also form after maintenance interventions in certain
weather conditions.
During dismantling must be installed caps on interface quick connectors on the inverter parts
that are installed and exposed to the elements.
Moreover must also be arranged the temporary ground connections to ensure the grounding
of all the parts of the inverter that remain installed on the system.
IP65
To Next Page
Loading...
