- Watch for the green LED to stop ashing remain ON if when self-tests
and grid checks are complete and the inverter starts production.
Any conguration of the inverter must be carried out
through Aurora Manager LITE software. The software and its
own manual are available at www.abb.com/solarinverters.
Possible LEDs behaviour are described in the following paragraph.
Enabling and default parameters
These main parameters are preset by the Manufacturer and can be
modied using the Aurora Manager Lite software.
• Date and time: It is set to UTC (daylight saving time is NOT considered).
• RS485 address:
RS485 (1) default setting on AUTO
RS485 (2) default setting on AUTO
• Vstart: 420 V
• Congurable relay (ALARM): default setting on “PRODUCTION”
• Remote control: OFF
• UV Protection Time: 60 sec.
• Reactive power: NO regulation.
• MPPT scan: ON (active) allows maximum power point tracking to be
carried out.
• Power reduction: 100%. No power limit activated.
To Next Page
Loading...
