The information is available through the dedicated software
This information is made available through the Aurora Manager LITE
software.
1. Product ID
This allows the model code and the T.ID code to be displayed which
identies the inverter hardware level.
2. Serial No
Allows you to view the equipment serial number.
3. Firmware
Displays the rmware version installed in the equipment and the “update
version” eld required to request a second-level password for the Service
menu (along with the Serial Number and Week of Production).
4. Country standard and language
Displays information on the grid standard set with the rotary switches.
• Actual value: Displays the grid standard set.
• New value: If the position of the rotary switches is changed (and
therefore a new grid standard is selected) during operation, the new
standard selected will be displayed. This will only become effective the
next time the equipment is turned off and then on again, and provided
the time remaining to carry out that operation has not expired (24h in
operation)
• Set new value: This allows you to conrm/set the new grid standard set
in the “New value” section of the previous menu.
• Residual time: Displays the time remaining in which it is still possible
to set a new grid standard. When the time expires, “Locked” will be
displayed, which indicates it is not possible to change the grid standard
again.
5. Fuse control (only for -SX / -SY versions)
• Strings: Displays the voltage and the state of the strings present at the
input of the equipment. A string can be in one of the following states: OK,
OFF (damaged) and ABS (Absent)
• Currents: Displays the current and the state of the strings present at
the input of the equipment. A string current can be in one of the following
states: OK, UNB (unbalanced current) and ABS (absent)
To Next Page
Loading...
