29
AcuRev 1300
Display interface
customization:increases
S-12 S-16 S-16 S-16 S-16
Display interface
customization: cut
S-13 S-17 S-17 S-17 S-17
Incorrect connection
detection enable
S-14 S-18 S-18 S-18 S-18
Each mode display area distinction as follows:
Important parameter mode: The rst
in the rst row do not display s, at the same
time, the mode setting position do not display
in the last row.
All parameter mode: The rst
in the rst row do not display s, at the same time, the
mode setting position display
in the last row.
Setting mode: The rst
in the rst row display s, at the same time, the mode setting
position do not display
in the last row.
Keys presentation:
1. Sealing key: Used as electronic sealing function.
2. Set key(SET): Used as LCD parameter setting.
According to the pressing time, there are 2 kinds of function:
A) Short time press (Set) (the press time is shorter than 2 second)
Used to enter the setting mode, enable setting, identify the setting.
3. Cycle key (SCOLL): used to change pages under the important parameter mode and
all parameter mode; under the setting mode, the key is used to change pages and data;
change the display mode.
According to the pressing time, there are 2 kinds of function:
To Next Page
Loading...
Need help?
General
