50
AcuRev 1300
4.7 Alarm function
AcuRev1300 series instrument event alarm function, which is of the denition of when a
parameter changes make events inequality (or) equation was established, and the duration
exceeds the preset time limit, the event alarm will be started at this moment, when the
alarm parameters of serial number, number, alarm status and alarm occurs as the event
was a record store at all times, there can be a maximum of 20 article such records stored
in the event log buer.And can be set as the limit of the RO as alarm output event alarm
signal output.Use the event before the alarm function seriously to complete a number of
Settings (conditions of inequality (or equations), can make the switch, etc.), any incomplete
or inaccurate setting will lead to the failure of the final output.Set up operations are
conducted based on the corresponding register set to complete.Need of special note is:
these register setting must be set by communication, and alarm value are the secondary
side of the measured values.Tool software setting the alarm display as shown in gure 4 - 8
.
Figure 4 - 8 Alarm Settings Page
To Next Page
Loading...
Need help?
General
