AccuEnergy AcuRev 1300 - 3.4 Settings and Operations

31
AcuRev 1300
dierent parameters. The change sequence is from the 1-29 screen(If the chosen
specication doesn't support the function , just skip it). When it comes to the last screen,
press the same key another time, back to the 1
st
screen.
3.4 Settings and Operations
Under the setting mode, the meter could complete most of the data setting.
Under the no setting mode, short pressing the “Set” (brief as “Set” blow) enters the
Password protection inquiry.
A) Password protectioninquiry
Password protectioninquiry is the key of key setting function. Only if input the correct
password, you can enter the parameter setting page. If users input wrong password, it
would quit the setting mode and enter the important parameter display mode. The factory
default password is 0000
Enter thepass word key operation:
Short press “SCOLL” key (Sc): the number in the cursor position plus 1, when the
number was 9, press the Sc would return to 0.
Short press “Set” key (Set): the cursor position move to right one, when the right-most
position ashing, press the “Set” again, it would be passwordinquiry. Password correct: go
to the meter address setting page. Password wrong: quit the setting mode and go to the