CHAPTER 8
ECLYPSE Web Interface
This chapter describes the ECLYPSE controller’s Web interface.
Overview
The ECLYPSE controller has a web-based interface that allows you to view system status, configure the controller, update
the controller’s firmware, and access applications associated to your projects. Note that if you intend on enabling FIPS
140-2 mode, it should be done prior to configuring the controllers. See FIPS 140-2 Mode.
Figure31: Example of an ECLYPSE Controller’s Web Interface Welcome Home Page (options may vary)
Web Interface Main Menu
The sidebar contains the configuration menus that allow you to view and set the controller’s configuration settings including
its IP address, Wi-Fi settings, users, controller’s firmware, and much more.
The menus may vary according to the associated device licenses and the user’s access level. These configuration param-
eters are password protected.
ECLYPSE Web Interface
41
nLight ECLYPSE
To Next Page
Loading...