Acuity Controls nLight ECLYPSE - Page 63

Figure57: SSO Server Settings - Server Mode Off
5. Select the Client Settings tab to setup the SSO client.
6. In Type, select Single Sign On. Additional fields are displayed.
Figure58: SSO Client Settings
7. In Server IP Address, enter the server IP address of the controller that is configured as the Server (e.g.,
192.168.0.10).
8. In Server Https Port, verify that the port number matches the HTTPS port number of the SSO server in System >
Web Server (e.g., 443).
ECLYPSE Web Interface
63
nLight ECLYPSE