£ FIPS 140-2 mode can’t be disabled without a factory reset: to disable FIPS 140-2 mode on an ECLYPSE controller, a
factory reset must be performed.
£ Wi-Fi is disabled: Enabling FIPS 140-2 mode will disable Wi-Fi. The controller can then be connected to a network only
via its Ethernet port, using an Ethernet cable.
£ Password requirements: When FIPS 140-2 mode is enabled, a stronger user password is required. The password
must be at least 14 characters long. As soon as FIPS 140-2 is enabled, the controller resets to a default username and
password, and the user will then be prompted to reset both.
– Default username: admin
– Default password: adminadminadmin
£ Radius server: On a project where the controllers have FIPS 140-2 mode enabled, a third-party Radius server cannot
be used. If the use of a Radius based authentication is required, an ECLYPSE controller must act as the Radius
server. In addition, third party Radius clients will not be able to connect to the ECLYPSE Radius server.
£ When GSA mode is active, the main ECLYPSE Configuration Portal login page can display a warning banner at the
top of the screen by setting the display banner option to ON.
The banner states the following message: “This is a U.S. General Services Administration Federal Government com-
puter system that is "FOR OFFICIAL USE ONLY.". This system is subject to monitoring. Therefore, no expectation of
privacy is to be assumed. Individuals found performing unauthorized activities are subject to disciplinary action includ-
ing criminal prosecution.”
ECLYPSE Web Interface
74
nLight ECLYPSE
To Next Page
Loading...
Need help?
General