• Press the "∧" button to answer "Yes."
After answering "Yes," the MP-2 will ask for confirmation:
• Press the "∧" button again to answer "Yes" and complete the store.
To abort the store process and return to editing:
• Press the PRGM EDIT button to reenter Program Edit mode. Select a section
and continue editing. All parameters will be as they were when you first
attempted to exit Program Edit mode.
To abort the store process and discard the changes to the program:
• Press the "v" button when the "Store in User Program 128? Y/ N" message
appears to answer "No."
• Press the "∧" button to answer "Yes" when the above message appears.
After the above message appears, the MP-2 will be in Play mode.
Pressing the "v" button to answer "No" to the abandon message will return you to the store
message.
Memory Protection
The MP-2 has a memory protection feature in the System Edit mode (discussed later) which
prevents any User program from being written to. The factory default setting for this feature is
"Off," however, should memory protection be turned on, it adds an additional confirmation
message to the store process. After responding "Yes" to the confirmation ("Are You Sure?")
message, the MP-2, when Memory Protect is set to "On," will briefly show this message:
Page: 25
To Next Page
Loading...
Need help?
General
