The name is kept as long as the MP-2 is in Program Edit mode, but is not permanent until
the program is stored.
Real-Time MIDI (RTM)
In this section, MIDI continuous controller messages received by the MP-2 can be assigned
to control parameters in real time. Up to sixteen assignments (also called "mappings") can be
made; each assignment is called a "slot." A single controller can be mapped to control a
number of different parameters, but each parameter can only be mapped to one controller.
For this reason, once a parameter has been mapped to a controller, it disappears from the
picklist of parameters which can be controlled. On the next page is the complete picklist.
Real-Time MIDI (RTM) is edited in this section using either of two modes, Quick or Expert,
and used in Play mode. (Which edit mode is used has no effect on RTM operation in Play
mode.) In Quick mode, assignment of MIDI controllers to MP-2 parameters is simplified to
make the process as fast and easy as possible, allowing only the parameter being
controlled to be viewed. Expert mode involves a few extra steps which allow direct
selection and viewing of slot number, controller number, controller sense and minimum
and maximum parameter values.
Page: 40
To Next Page
Loading...
Need help?
General
