then change to:
The User program value shown is the last User program used by the MP-2. Note that only User
programs are available for storing.
• Use the BANK UP, BANK DOWN, and number buttons in the same fashion as
recalling a program in Play mode to select a User program other than the one
shown.
• When the desired User program is selected, press the "∧" button to answer
"Yes" to the query. The MP-2 will ask for confirmation:
• Press the "∧" button again to answer "Yes" and complete the store.
To abort the store process and return to editing:
• Press the PRGM EDIT button to reenter Program Edit mode. Select a section
and continue editing. All parameters will be as they were when you first
attempted to exit Program Edit mode.
To abort the store process and discard the changes to the program:
• Press the "v" button when the "Store in User Program 128? Y/ N" message
appears to answer "No."
• Press the "∧" button to answer "Yes" when the above message appears.
After the above message appears, the MP-2 will be in Play mode.
• Pressing the " v" button to answer "No" to the abandon message will return you to the
store message.
NOTE: It may helpful to refer to the signal flow diagram at the front of the manual to understand
the position of the following functions.
Page: 35
To Next Page
Loading...
Need help?
General
