General procedure for making RTM assignments in Expert Mode:
• Press the REAL-TIME MIDI button to enter the section if it is not already
selected.
• Set RTM Edit Mode to "Expert".
• Select Slot to be programmed.
• Select Parameter to be controlled.
• Select MIDI Controller number.
• Set the controller Sense.
• Set the Minimum and Maximum allowable values for the parameter under
control.
• Check the operation of the mapping in Real-Time MIDI Preview.
Compare
This feature allows comparison, without leaving Program Edit mode, between an edited
(Modified) version of a program and the stored version (Original). Each time the Compare
button is pressed, the MP-2 switches between the versions, allowing each to be heard. The
display indicates whether it is switching to the edited version ("MODIFIED SETTINGS") or
the stored version ("INITIAL SETTINGS").
System Edit Mode
Utility functions and MIDI parameters which are global (in effect for all programs) are found
in System Edit mode. Many functions in this mode have procedures of several steps which
are entered with the up arrow.
NOTE: Simultaneously pressing the "∧" and "v" buttons clears all Slots (unassigns all
To Next Page
Loading...
Need help?
General
