Chapter 11: Solving Problems ● 142
Understanding Error and Warning Messages
This section provides detailed information about error and warning events that occur in Adaptec Storage Manager.
Warning Messages
Error Messages
Warning Warning Message Text
ArrayCritical Ready disk drives are still available
HotSpareTooSmall The hot spare is too small to protect the specified array
HotSpareWontWork At least one logical drive is not protected by the specified hot spare
InitLD Hot spare is too small for use by at least one array
NoService The specified logical drive was not initialized
SyncLD Could not contact Adaptec Storage Manager Agent. Adaptec Storage Manager may not function correctly.
Please start the Agent.
Error Error Message Text
AbortTask Could not stop the specified currently running task
AccessControl Could not write the logical drive access control list
AddToDiskSet Could not add drives to the specified diskset
AgentRemoved Could not remove the specified Agent
ArrayInUse Could not delete the specified array. One or more initiators are logged into a logical drive(s)
contained within this array
ArraysInUse Could not delete all of the specified arrays. One or more initiators are logged into a logical
drive(s) contained within this array
BreakRemoteMirror Could not break the specified remote mirror facet
CalibrateBatteryController Could not recalibrate the specified battery
ChangeArraylName Could not change the name of the specified array
ChangeBIOSMode Could not change the BIOS-compatibility mapping
ChangeDiskSetName Could not change the name of diskset
ChangeLogicalLun Could not change the LUN of the specified logical drive
To Next Page
Loading...
