Configuration and Activation 4-95
12. Once activation is complete, the status bar displays Activate
successful.
13. Click on the Hangup button in the Functions section when
you are finished running diagnostics on sensors associated with
the current monitor.
14. Click on the Save button to save any changes in the device
parameters to the local directory or network.
15. Qstart
XML
generates a log entry for each user-initiated
diagnostic reading taken by the monitor that includes the
sensor fired, date and time at which the measurement was
taken, current device parameters corresponding to the sensor,
and readings and associated results. This entry (or entries) are
available for viewing through the log viewer in Qstart
XML
.
To Next Page
Loading...
