Sensor Installation and Connection 5-43
(38.1m), 150 ft. (45.7m), and 200 ft. (61.0m). All other lengths must be custom
ordered.
4
The external power/communications cable and the ground cable included in the
external power grounding kit can be ordered to specific lengths up to 800 ft. (243m).
Note the desired length (in feet) in the –xxx portion of the part number. Standard
lengths are 10 ft. (3.0m), 25 ft. (7.6m), and 100 ft. (30.5m). All other lengths must
be custom ordered.
Gathering the Tools and Equipment
Gather the following tools for the installation:
z Battery-powered hammer drill with assorted bits – including
the following at a minimum:
¼-inch (6-mm) x 6-inch (150-mm) masonry bit
3/8-inch (10-mm) x 4-inch (100-mm) [minimum length]
masonry bit
5/16-inch (8-mm) carbide-tipped bit
z Heavy 4-pound (1.5-Kg) hammer
z Rubber mallet
z 24-inch (610-mm) carpenter’s level
z Nut driver set or socket set (English plus 13-mm for canister
hardware)
z Wrenches (English plus 13-mm for canister hardware)
z Screwdrivers (flathead and Phillips head of assorted sizes)
z Threads tap compatible with the thread spec on the monitor
mounting stud
z Diagonal wire cutters
z Folding carpenter’s rule with a brass slide
z Mastic tape (ADS p/n 507193) or rubber coaxial stretch tape
To Next Page
Loading...
