11-28 ADS TRITON+ Manual
four (4) digits of the SIM ICCID number and TRITON+ serial
number. Once the SIM card is deactivated, you may discard it.
14. Request an activation of the new SIM by emailing
ADSEODIP@idexcorp.com (or the network service provider).
Include the last four (4) digits SIM ICCID number and modem
IMEI number. Wait for return email from ADS (or the network
service provided) that the SIM has been activated. The email
will contain the IP address (for static IPs) and its associated
phone number.
Note: Wait at least 15-minutes from the receipt of the
email before proceeding with the next step. This is to
ensure sufficient time for the IP address to be uploaded by
the service provider.
15. Connect an ADS USB Serial Interface cable (ADS p/n 8000-
0337) to the COMM + EXT PWR port on the monitor (for
battery powered monitors) or a standard A-to-B USB cable to
the USB port on the ExPAC (for externally-powered monitors).
Attach the other end of the USB cable to your laptop computer.
16. Reactivate the monitor through Qstart
XML
.
Note: You must reactivate the monitor through a direct
(serial) connection before you can resume wireless
communications following SIM card replacement.
17. Establish wireless communication with the monitor to verify
communication.
18. Recoil and secure the antenna cable to the cable tie mount
using a cable tie, if necessary. Refer to Installing the Antenna
in Chapter 3, Communication, for more information.
Replacing the SIM Card in Regular/Modem Bowl
Note: The only service or maintenance activities ADS
permits within the monitor chassis are battery pack, battery
PCB, regulator/modem unit, SIM card replacement (as
applicable) and fuse replacement. Therefore, do not
handle, alter, modify, remove, or replace any other
To Next Page
Loading...
