ADS TRITON+ - Page 521

Index In-5
dryer tube, 5-99
desiccant, 11-21
end-cap, 5-100
replacement, 11-21
replacing the desiccant, 11-22
securing to the monitor, 5-99
duration, 4-75
dynamic IP, 3-4
E
electronic offset, 4-28, 4-32, 4-51, 4-
54, 4-65, 4-70, 4-81
Enable Scrubbing, 4-35, 4-59, 4-79
entity
ANGLE, 8-6
events
testing monitor cryouts, 11-9
ExPAC, 1-5, 2-3, 2-12
diagnostic codes, 11-42
installation, 6-10
mounting to DIN rail, 6-10
mounting to wall, 6-14
installation and wiring, 6-18, 6-29
Modbus, 2-36, 10-1
RS-232 connection, 10-6
RS-485 connection, 10-2
RS-232 connection, 10-6
RS-485 connection, 10-2
running the ground wires, 6-22
specifications, A-21
wiring to the monitor, 6-29
wiring to the power supply, 6-18
extension cables, 5-42, 5-63
external power
consumption, 6-3
ExPAC, 2-12
ExPAC, 1-5
grounding kit, 6-29, 6-34
installation, 6-2
ExPAC, 6-10
power supply, 6-7
XBUS, 6-5
XIO, 6-5
monitor COMM + EXT PWR
port, 2-10
requirements, 6-3
running the ground wires, 6-22, 6-
29, 6-34
supplying to system, 6-36
wiring the AC power cable to the
power supply, 6-15
wiring the monitor to the ExPAC,
6-29
wiring the monitor to the XBUS,
6-29
wiring the monitor to the XIO, 6-
29
wiring the power supply to the
ExPAC, 6-18
XBUS, 1-5
XIO, 1-5, 2-12
external power grounding kit, 6-29,
6-34
F
firmware updates, how to, 4-103
Flow, 4-42
Flow Loss, 4-43
flow type, 4-28, 4-34, 4-51, 4-57
flumes, 4-12
fuses
replacement, 11-35
G
gain, 4-75
ground connection facility, 6-22, 6-
23, 6-29, 6-34
ground wires
connecting to the ExPAC, 6-22
connecting to the monitor, 6-29, 6-
34
connecting to the XBUS, 6-22
connecting to the XIO, 6-22
connecting to XBUS, 6-22
connecting to XIO, 6-22