ADS TRITON+ - Page 524

In-8 ADS TRITON+ Manual
Mounting Bar installation, 5-64
overview, 2-20
part number, A-9
part numbers, 2-20
physical offset, 5-75
power,
4-48
securing sensor cables, 5-95
specifications, A-9
Submersion Sensor, 2-22, 5-74
temperature,
4-47
troubleshooting, 11-53
wall mount, 5-71
Longitude, 4-14
lookup tables, 4-12
low voltage, 11-9
M
maintenance
checking the sensors, 11-20
parts and supplies, 11-2
restrictions, 1-9
sensor inspection, 11-20
SIM card replacement, 11-24
system components, 11-2
manhole
conditions, 5-5
depth, 5-6
mounting the monitor
manhole rim, 7-7
manhole wall, 7-4
rung, 7-3
securing sensor cables, 5-95
maximum velocity, 4-59, 4-74, 4-79
memory, 2-2
Modbus, 2-36, 4-90
configuration, 10-10, D-2, D-4
connecting through the ExPAC
RS-232 port, 10-6
connecting through the ExPAC
RS-232 port in the XBUS, 10-6
connecting through the ExPAC
RS-485 port, 10-2
connecting through the ExPAC
RS-485 port in the XBUS, 10-2
output data registers, 10-11
SCADA, 10-1
setting up a wireless connection,
10-9
Telog Ru-33, D-2
verifying output data, 4-90
Wavelet 4R, D-4
XBUS, 10-2, 10-6
mode, 4-65
modem, 1-5
antenna connection to monitor, 3-
20
ceritification, 1-13
installing the wireless antenna, 3-
10
replacing the SIM card, 11-24
testing monitor cryouts, 11-9
Modem Setup, 4-19
Modem Setup, 4-18
Modem Setup
editing device, 4-19
Modem Setup
APN username and password, 4-
19
moisture in pressure depth sensor,
11-21, 11-22
monitor
12-volt IS battery pack
checking voltage, 11-9
replacement, 11-12
activation, 4-88
activity codes, 11-6, C-1
configuration
Modbus, 10-10
confirmation, 11-4
connecting a water quality
sampler, 5-97
connecting communication cable
to ExPAC, 6-29
connecting communication cable
to XBUS, 6-29
connecting communication cable
to XIO, 6-29