ADS TRITON+ - Page 527

Index In-11
3/4-band mount, 5-45
3/4-band mount with silt mount
adapter, 5-47, 5-50
silt mount adapter, 5-47, 5-50
IS certification, 1-5
overview, 2-28
peak velocity measurement, 2-
29
pressure depth measurement, 2-
28
upward ultrasonic depth
measurement, 2-28
pressure sensor dryer tube
replacing desiccant, 11-22
replacing pressure sensor dryer
tube, 11-21
securing dryer tube to the monitor,
5-99
silt mount adapter, 5-24, 5-47, 5-
50
special installation, 5-44
specifications, A-14
troubleshooting
peak velocity, 11-63
pressure depth, 11-68
temperature, 11-70
upward ultrasonic depth, 11-60
peak velocity
editing sensor device parameters,
4-56, 4-77
measurement, 2-27, 2-29, 2-33
troubleshooting, 11-63
physical offset, 4-50, 4-67, 4-69
Surface Combo Sensor, 5-35
Ultrasonic Depth Sensor, 5-35
ping amplitude, 4-30, 4-36, 4-53, 4-
60, 4-76, 4-80
pipe
conditions, 5-5
dimensions, 5-6
securing sensor cables, 5-95
shape, 5-6
pipe height, 4-27, 4-51, 4-67, 4-70
ports, 2-9
connecting a water quality sampler
to the monitor, 5-97
connecting sensors to the monitor,
5-97
power, 1-5
12-volt IS battery pack, 2-3, 2-11
battery pack, 1-5, 2-3
replacement, 11-12
checking battery pack voltage, 11-
9
consumption, 6-3
ExPAC, 1-5, 2-3, 2-12
external, 6-1
ExPAC, 6-18, 6-29
installation, 6-2
mounting the XBUS, 6-5
mounting the XIO, 6-5
power supply, 6-15, 6-18
requirements, 6-3
running the ground wires, 6-22,
6-29, 6-34
supplying to system, 6-36
XBUS, 6-29
XIO, 6-29
internal
12-volt IS battery pack, 2-11
checking battery pack voltage,
11-9
replacing the battery pack, 11-
12
regulator
replacement, 11-35
replacing fuses, 11-35
replacing the regulator, 11-35
running the ground wires, 6-22, 6-
29, 6-34
supply to system, 6-36
wiring the AC power cable to the
power supply, 6-15
wiring the monitor to the ExPAC,
6-29
wiring the monitor to the XBUS,
6-29
wiring the monitor to the XIO, 6-
29