Advantech-DLoG DLT-V72 Series - Wi-Fi Configuration; Safety Notice

Device configuration
28 / 94 DLT-V72 Series Manual V2.00 Advantech-DLoG
6.2. Wi-Fi configuration
Depending on the optional equipment and intended use of the DLT-V72, the settings and access data
for Wi-Fi networks must be defined.
6.2.1. Safety notice
CAUTION
Danger of radiation emission.
This device emits high-frequency energy (abbreviation: HF). To protect people from HF
radiation and to comply with country-specific regulations, e.g. of the USA and Canada:
 Install the DLT-V72 so that persons maintain a minimum distance of 20 cm to the antenna.
The DLT-V72 may only be utilized together with the following wireless modules:
PE15N
FCC ID: TWG-SDCPE15N
IC ID: 6616A-SDCPE15N
WPEA-252NI
FCC ID: RYK- WPEA252NI
IC ID: 6158A-WPEA252NI
For the Wi-Fi configuration: Set the correct transmitting power and frequency.
Risks to health are possible due to excessive radio wave emission if the transmission power
and the frequency are set incorrectly during the Wi-Fi configuration.
 Observe the applicable regulations for your deployment location/country with regard to
frequencies and the maximum permissible transmitting power. Responsibility for this lies
with the company operating the DLT-V72. The regulatory authorities in the relevant country
can provide information on this.
Country-specific regulations
Example Germany: In Germany according to regulations published in the gazette 89/2003 of the RegTP
(regulating body for telecommunications and mail, now: “Bundesnetzagentur”) - Federal Network Agency
for electricity, gas, telecommunications, post and railway - the maximum permissible transmitting power,
EIRP (Equivalent Isotropically Radiated Power), in the 2.4 GHz frequency band is set at 20 dBm (100
mw).
 Set the transmitting power of the Advantech-DLoG antenna so that the permitted EIRP limit value is
complied with.