AMT-70/AMT-73/AMT-75 Installation and Operation
3
2.1 Jan 19, 2005
- Changed RS-485 pin-out to reverse TX+ & TX-
- Created Appendix A from previous sections of manual
regarding Antenna & cable info
- Added Appendix B, (S+N)/N Conversion Charts
- Added Mod and Demod Fault Status and pin-outs
- Changed ifrxclock in Packet Protocol section (Chapter
12) to read “0=internal; 1=demod (was external)
- Updated Front Panel Display Menus
2.2 Feb 26, 2005
- Updated Connector section – added reference to AMT-
70 and AMT-73L
- Changed MONITOR RX POWER.AGC to reflect dB
- Update Packet Protocol Section 7.3 to
Version 1.17Y
- Updated Configuration Option Chart to Version 3
- Inserted new drawings to reflect AMT-70 and 73L front
and rear panels
- Added paragraphs in Chapter 4 plus simplified block
diagram to reflect Clocking, Loopback functions, and
BER testing.
- Added paragraph on setting Continuous Carrier Mode
- Added Appendix B to include Eb/No to (S +N)/N
Conversion Charts
- Added ¾ Rate eTPC to AMT-70/73 Technical specs.
- Changed TREF to TFREF in paragraph 2.8 and added
support in paragraph 3.2.
- Added packet protocol update (Chapter 12).
- Added AMT-70L/73L Demod Input Level versus Symbol
Rate Charts in Appendix A.
- Upgraded Packet Protocol to V1.19
- Removed and incorporated Section 6 with Section 4.
- Added static DEFAULT Commands
- Moved Chapter 12 to Chapter 7 – for better flow of the
document
- Changed Chapter 4 Title to MODEM M&C
INTERFACES
- Added Quick Start Guide to Chapter 4
2.3 Mar 20, 2005
- Reformatted manual.
- Made correction to several text errors.
2.4 June 20, 2005
- New Front-Panel interface design
- Commands IFTDINV , IFRDINV. IFBUFMON
added for the data interface.
- RSPANL new parameter AUTO
- LOG subsystem enhancements
- Updated INTERFACE card sections
- Updated REDUNDANCY chapter
- RS485CONF, NETCONF new commands
- Packet Protocol Changes to V1.18
2.5 June 30, 2005 - SNMP support added
2.6 Aug 11, 2005 - AERo Embedded Router support added
To Next Page
Loading...