AMT-70/AMT-73/AMT-75 Installation and Operation
rwcommunity = private
=> snmpcfg trapsink
trapsink = 0.0.0.0
=> snmpcfg trapcommunity
trapcommunity = public
5.12.3 The SNMP MIB source file
You can get the SNMP agent MIB source file using one of the two methods below;
1.- Through your sales representative.
2.- By uploading the file from your modem; upload the file “amt70_mibs.mib”
from the “/sbin” directory.
5.13 Modem events and logging
The modem can report unsolicited events (hardware or software) to the end-user through three
different mechanisms;
1.- The Serial Port master console interface
2.- The internal LOG file
3.- SNMP Traps
The following events are reported as follow;
Event
Trap #
Message Description LOG SNMP CONSOLE
1 Startup Completed This event occurs after the modem is
rebooted and the software is
initialized
yes yes no
2 BUC Power state The BUC power was turned ON yes yes no
3 no The BUC power was turned OFF yes yes
4 LNB Power state The LNB power was turned OFF yes yes no
5 The LNB power was turned ON yes yes no
6 Modulator output state The modulator output is DISABLED yes yes no
7 The modulator output is ENABLED yes yes no
8 Modulator TX state The modulator is READY to transmit yes yes no
The modulator is in FAULT state yes yes no
9 Demodulator lock state The demod is UNLOCK yes yes no
10 The demod is LOCK yes yes no
11 Shutting down This message appears just after the
mod / demod software are resetted.
yes yes no
93
Figure 3 : The modem log events
5
To Next Page
Loading...
General