AMT-70/AMT-73/AMT-75 Installation and Operation
4.2.5.1.2 Available settings and parameters
The general menu below shows all the options relative to all modes. Depending on the selected mode
some parameters may not be valid and hence will not be displayed as options.
Figure 15: Front Panel Display TX (transmit) Menu
TX Menu 1
TX Menu 2
TX Menu 3
66
T X : M O D = Q P S K C A R R . F R Q = 1 2 0 0 0 0 0 0 0 H z
B P S K
(Carrier Freq. from 950,000,000 to 2,000,000,000Hz – L Band IF)
O Q P S K Q
(Carrier Freq. from 104 to 176 MHz – 140 MHz IF)
O Q P S K I
(Carrier Freq. from 52 to 88 MHz – 70 MHz IF)
1 6 Q A M
8 P S K
U N I T S = B P S DATA=002048000 b p s .
S P S
(Data Rate from 32,000 to 150,000,000bps or sps)
T X : C O D E = N O N E P O
ER=- 15db m
O M 7 3
(Power from 0 to -25 dBm in 0.1 dB steps)
T P C 1 6 K
T P C 4 K
I N T E L S AT
D S N G
D V B S
R A T E = 7 / 8 RSRATE=OFF
5 / 6 126
3 / 4 219
2 / 3
1 / 2
1 9 / 2 0
8 / 9
3 / 5
2 / 5
To Next Page
Loading...
General