Aerco Benchmark 2000 User Manual

Benchmark 1500 - 2000 Boilers
CHAPTER 3 – OPERATION
OMM-0097_0E AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 41 of 182
GF-142 Ph.: 800-526-0288 10/01/2015
3.4 OPERATING MENU
The Operating menu displays a number of key operating parameters for the unit as listed in
Table 3-2. This menu is “Read-Only” and does not allow personnel to change or adjust any
displayed items. Since this menu is “Read-Only”, it can be viewed at any time without entering a
password. Pressing the ▲ arrow key to display the menu items in the order listed (Top-Down).
Pressing the ▼ arrow key will display the menu items in reverse order (Bottom-Up).
Table 3-2: Operating Menu
Menu Item Display
Available Choices or Limits
Minimum
Maximum
1
Active Setpoint
40°F (4.4°C)
240°F (116°C)
2
Inlet Temp
40°F (4.4°C)
140°F (60°C)
3
Air Temp
-70°F (-56.7°C)
245°F (118°C)
4
* Outdoor Temp
-70°F (-56.7°C)
130°F (54.4°C)
5
Valve Position In
0%
100%
6
* Valve Position Out
0%
100%
7
Exhaust Temp
Current Temp, Read Only, in °F
8
Flame Strength
0%
100%
9
Oxygen Level
0%
21%
10
Run Cycles
0
999,999,999
11
Ignition Time
0.00
10.00
12
SSOV Time to OPN
0.00
10.00
13
Run Hours
0
999,999,999
14
Fault Log
0
19
*NOTE
The Outdoor Temp and Valve Position Out display items shown
with an asterisk in Table 3-2 will not be displayed unless the
Outdoor Sensor function has been enabled in the Configuration
menu (Table 3-4).

Aerco Benchmark 2000 Specifications

General

Brand	Aerco
Model	Benchmark 2000
Category	Boiler
Language	English