AfiMilk MPC 3 - System Parameter Setup

AfiMilk MPC Installation Manual 62
Chapter
7
First Time Operation
Setting-Up Parameters
There are two ways to set-up parameter values in Afimilk MPC. The most convenient way
is at the computer, in afimilk, for sending the values to Afimilk MPC displays via
communication. Since most parameters are set uniformly for all the milk meters in the
parlor, this method provides additional protection against mistakes.
Parameter values can also be set at each Afimilk MPC control box. This method is used
mainly in standalone setup where afimilk is not available. Refer to the chapter "Setting-up
parameters via the control box" for further instructions regarding this option.
Afimilk MPC and AfiMilk Configuration
When setting up the systems' configuration for afimilk, Afimilk MPC needs to be selected
as the milk meter type for the parlor setup.
Refer to AfiFarm 5 installation manual for further instructions regarding the setup of
milking parlors.
Once set and communication established, AfiMilk MPC operation parameters may be
accessed and set from the AfiControl interface (See screen at the following page)
Note
After setting AfiMilk MPC parameter values in the parameters table, press
Commit to accept changes