AfiMilk MPC 3 - Cow-Specific Milking Operations

AfiMilk MPC Installation Manual 86
Chapter
8
Unique Setup & Configurations
Assigning Milking Operations to specific cows
AfiMilk allows assigning nonstandard milking operations to specific cows in the herd. This
is done for tuning milking for cows per unique needs.
The milking parameters available for such individual cow assignment are those in AfiMilk
MPC COW parameter group.
The concept of operation of this feature is based on codes assigned to specific cow
population (either manually OR automatically by a filter). Once such code is built, afifarm
allows assigning either one of the milking options to that code.
Security levels are assigned to codes the same way (Start key behavior, code appearance
etc.). The following sections describe the setup procedure inside afifarm for assigning
security level and milking parameter to a code.
Settings Interface
To set and assign security level or milking operations to codes enter the "Operations"
screen in AfiControl via the following path:
>Settings>Parameters
In the parameters
screen highlight the
"Parlor" site and Select
the "Operations" tab.
The screen that opens
allow you to set alert
level and operation to
each of the codes
defined in AfiFarm 5.